Programing Direct DVR(Digital Video Recorder) Remote

Posted by tvkota

August 27, 2008

To use Direct DVR in order to get the capability with the television function like volume and channel we must find the code first. But this may difficult to find the code as there are many codes in every brand of DVR and the unlucky is DVR won’t able to remote your TV as the code is not suitable.

To overcome this problem we can search the codes one by searching the codes over searcher feature. By this way you will find the match code and in order to get the access to remote your TV done by DVR. For this problem there is a problem which is simpler than ways has told out. But this way won’t work for some TV list below:

It will not work with TV that built in DVD player and VCR
It will not work with old Tivo model.
still doubt to be used in HD DVR or high definition DVR. It may can work but it still need the addition equipments.

So before you apply this way for your Television, make sure that your TV is not one of the TV’s model listed above. Here are the steps :

Make sure that your tv is in on position (turn on your TV)
Place the switch in at the top of your remote control which allow you to toggle among receiver, auxilary and the TV modes stir the switch to TV.
Hold Mute and then choose until you find small green light located at the top blinks twice.
Enter the code 9911
press and repeat the channel until your TV turn off, then press select
Turn your TV on
Run the third sterp
insert code 960
Slide switch back over to your DTV and you will find your remote ready in use.

How easy and simple it is. Beside that you don’t need to call costumer service which mean that you will save your money. Good luck

Share and Enjoy: These icons link to social bookmarking sites where readers can share and discover new web pages.